Have you refreshed your browser (or cleared your browser cache)
--
_____________________________________________
SBR @ ENJOY (-: [ Microsoft MVP - FrontPage ]
"Warning - Using the F1 Key will not break anything!" (-;
_____________________________________________
| No I added some text, an icon, and a hyperlink for that icon. It was all
| added on the local page through Frontpage. When I try to publish the local
| site to remote, no changes take place on the remote site, though I get a
| message saying it was succussful.
|
| "Stefan B Rusynko" wrote:
|
| > By adding stuff, did you add it thru FP
| > - If not Run a Tools Recalculate Hyperlinks before publishing
| >
| > --
| >
| > _____________________________________________
| > SBR @ ENJOY (-: [ Microsoft MVP - FrontPage ]
| > "Warning - Using the F1 Key will not break anything!" (-;
| > _____________________________________________
| >
| >
| > | Did a browser cache clearing going through the IE tools menu and one through
| > | CCleaner. Then did a full publish followed by a changed pages only publish.
| > | Still it did not change.
| > |
| > | "Tom [Pepper] Willett" wrote:
| > |
| > | > Since you have done a clean install, you need to get your webs back in
| > | > synch. Do a FULL publish one time, not just a changed pages, and that
| > | > should get you back.
| > | >
| > | > Also, make sure you have cleared your browser cache.
| > | > --
| > | > Tom [Pepper] Willett
| > | > Microsoft MVP - FrontPage
| > | > "You're a daisy if you do!"
| > | > ---
| > | > FrontPage Support:
| > | >
http://www.frontpagemvps.com/
| > | > ===
| > | > | > | > :I have published a website using FP 03 I went back in and added some stuff
| > | > and
| > | > : tried to republish, but when I tried it said it was successful but none of
| > | > : the changes actually took on the remote site. It used to work fine, but I
| > | > had
| > | > : to do a clean install on my computer and since then, no luck. I am at a
| > | > loss.
| > | > : So far I have tried:
| > | > :
| > | > : Close all open Web sites, then choose Open Site from the File menu and
| > | > make
| > | > : sure to specify your local Web site.
| > | > :
| > | > : Then, make sure that Remote Web Site Properties shows the remote Web site.
| > | > :
| > | >
| > | >
| > | >
| >
| >
| >
