Red handles on conn point no showing

J

Jason V

I have created a shape and added several connection points but it is not
highlighting red and connecting when I place it. I can make several other
shapes that do but this one does not. My snap and glue is set right but it
does not work in this shape. ANy ideas?
 
P

Paul Herber

I have created a shape and added several connection points but it is not
highlighting red and connecting when I place it. I can make several other
shapes that do but this one does not. My snap and glue is set right but it
does not work in this shape. ANy ideas?

It depends a lot on what your shape is and what you are connecting it
too, or what you are connecting to it.

Open the shape's shapesheet and look at the connection points type,
it's normally 0, try 1 and 2 instead.
2 is most likely to have a significant effect.
 
J

Jason V

I have set these to 2 but sometimes they still do not work. As a test I
created 2 rectangles and in all four corners of each on I created connection
points and gave then all ype 2. For some reason some will connect and some do
not. I have not determined why the ones that work do and the ones that do not
work don't.

??
Thanks
 

Ask a Question

Want to reply to this thread or ask your own question?

You'll need to choose a username for the site, which only take a couple of moments. After that, you can post your question and our members will help you out.

Ask a Question

Top