G
Gary
I have notice that when I embed Visio into a OLE field on a table. I save
the Visio with certain layers visible unless one changes it. When I double
clip or open the embed OLE object (which is my Visio drawing), I see all of
the layers being visible.
That is a the problem. The problem is that if I save the information on
which layer is to be not visible, then when I open Visio from the able and
closes it, it makes all of the layers visible again. I would like to have
the original values restored.
I assume I must take advantage of OnOpen and OnClose commands. I could use
VBA to save the fields that is critical.
Does anyone have any suggestions.
the Visio with certain layers visible unless one changes it. When I double
clip or open the embed OLE object (which is my Visio drawing), I see all of
the layers being visible.
That is a the problem. The problem is that if I save the information on
which layer is to be not visible, then when I open Visio from the able and
closes it, it makes all of the layers visible again. I would like to have
the original values restored.
I assume I must take advantage of OnOpen and OnClose commands. I could use
VBA to save the fields that is critical.
Does anyone have any suggestions.