Separator problem on Cross Functional Flowchart

[Buddy]

I inherited a cross-functional flowchart and need to make some changes to it.
I am trying to add a separator to the diagram, but it is not functioning
properly. When I drag the separator over from the stencil, it doesn't extend
all the way down the diagram. In fact, I can drag it anywhere on the
diagran, not just in the band immediately below the title. When I try to
copy and paste an existing separator, it pastes far above the flowchart, off
the page. It does automatically extend to the bottom of the flowchart, but I
cannot move it vertically so that it sits in its proper place (in the band
below the title).

I've posted screenshots of what I describe above at
http://www.flickr.com/photos/13593099@N05/

Anyone have any ideas as to what's wrong and how I can fix it? This a
pretty big and complex diagram, and I would hate to have to re-create it.

Thanks.

 

[Paul Herber]

I inherited a cross-functional flowchart and need to make some changes to it.
I am trying to add a separator to the diagram, but it is not functioning
properly. When I drag the separator over from the stencil, it doesn't extend
all the way down the diagram. In fact, I can drag it anywhere on the
diagran, not just in the band immediately below the title. When I try to
copy and paste an existing separator, it pastes far above the flowchart, off
the page. It does automatically extend to the bottom of the flowchart, but I
cannot move it vertically so that it sits in its proper place (in the band
below the title).

I've posted screenshots of what I describe above at
http://www.flickr.com/photos/13593099@N05/

Anyone have any ideas as to what's wrong and how I can fix it? This a
pretty big and complex diagram, and I would hate to have to re-create it.

Post a minimal version (just the functional bands frame) on the Visio Guy site. I'll
compare it with a normal frame.