R
rhatcher
I have a shape group that has been rotated so that the bottom plane of
the shape is at approximately a 45 deg angle. This plane has an
Outward connection point. When I move this shape to the connection
point it mates with, it snaps to the point, but when I release the
mouse button the group offsets itself to one side. The only "snap
to" points enabled is "connection points.
Any suggestions on how to get the shape to stay were it snaps to in the
first place?
the shape is at approximately a 45 deg angle. This plane has an
Outward connection point. When I move this shape to the connection
point it mates with, it snaps to the point, but when I release the
mouse button the group offsets itself to one side. The only "snap
to" points enabled is "connection points.
Any suggestions on how to get the shape to stay were it snaps to in the
first place?