B
Bob@GTT
I have 10 parts that I have measured 2 hole on. One hole is on the front
face and the 2nd hole is on the back face. The CMM gives me an X and Z
dimension with a nominal. My question is, is there any way to use these
dimensions to calculate the skewness of these holes? I tried using the X and
Z values from Hole 1 and the X and Z values from Hole 2, but I am not sure if
this is correct or not.
Thanks
face and the 2nd hole is on the back face. The CMM gives me an X and Z
dimension with a nominal. My question is, is there any way to use these
dimensions to calculate the skewness of these holes? I tried using the X and
Z values from Hole 1 and the X and Z values from Hole 2, but I am not sure if
this is correct or not.
Thanks