W
WJ Shack
I upgraded to 10.3.1 recently and have been using Solver today with some
peculiar results. If I run Solver everything seems to work fine, except
that after Solver arrives at an answer and throws up the dialog to ask if I
want to keep the Solver solution, my workbook window goes blank. No grid or
anything else is visible. Solution is to close the dialog window, close the
blank workbook window and open it again. Then run Solver again. About half
the time it works OK, half the time I get the blank window. Anybody else
seen this behavior?
peculiar results. If I run Solver everything seems to work fine, except
that after Solver arrives at an answer and throws up the dialog to ask if I
want to keep the Solver solution, my workbook window goes blank. No grid or
anything else is visible. Solution is to close the dialog window, close the
blank workbook window and open it again. Then run Solver again. About half
the time it works OK, half the time I get the blank window. Anybody else
seen this behavior?