C
Chris Ellefson
I have encountered this problem several times (Access
97). When I develop a switchboard I always create a
switchboard button that points to another switchboard
(Reports). This contains a number of reports I can
generate at the click of a button. After the switchboard
has been created, I run it to see if everything works
OK..it does. Then I create a macro to maximize the
switchboard form as well as open the form upon START UP.
After I do this the REPORT button becomes non-
operational. Then I have to start over from scratch.
After the second time through it works correctly. Is
there anything I can do within access to fix the
switchboard without having to start over again? Thanks!
97). When I develop a switchboard I always create a
switchboard button that points to another switchboard
(Reports). This contains a number of reports I can
generate at the click of a button. After the switchboard
has been created, I run it to see if everything works
OK..it does. Then I create a macro to maximize the
switchboard form as well as open the form upon START UP.
After I do this the REPORT button becomes non-
operational. Then I have to start over from scratch.
After the second time through it works correctly. Is
there anything I can do within access to fix the
switchboard without having to start over again? Thanks!