C
coryb891
I inserted a line into a diagram in Word 2007 and then went to the
"Format Autoshape". I didn't do a thing, but when I click on another
tab I get the message "The measurement must be between 0" and 0.32"".
When I click on cancel, I get the same thing. Click OK - same thing.
Everything in the dialog is disabled and grayed out except 2 up/down
controls - "Absolute" underneath "Height" and "Absolute" underneath
"Width." I have tried changing these to all sorts of values and none
of them satisfied it. What is going on here?? I can't even save my
work!!
"Format Autoshape". I didn't do a thing, but when I click on another
tab I get the message "The measurement must be between 0" and 0.32"".
When I click on cancel, I get the same thing. Click OK - same thing.
Everything in the dialog is disabled and grayed out except 2 up/down
controls - "Absolute" underneath "Height" and "Absolute" underneath
"Width." I have tried changing these to all sorts of values and none
of them satisfied it. What is going on here?? I can't even save my
work!!