M
Matsi
I am creating a pivot table in Visio - pulling the information from an excel
spreadsheet (insert pivotdiagram) and following the steps. When the page
comes up, I get "VisioSelection$-73" (was $-72 for a while, and $-71 prior to
that), and there is a small square that blocks out part of the word
Selection, and it's connected by a connector the length of the page, to the
box that I wanted to start with. The small square at teh top that blocks the
word has a yellow diamond shape in it. I cannot remove the connector, or the
square, thus I'm having difficulty continuing on with my page. Yesterday I
could close the app and open it again and I'd be fine, but by the end of the
day - even that wasn't a solution. Can ANYONE help me? Should I be under
development???
spreadsheet (insert pivotdiagram) and following the steps. When the page
comes up, I get "VisioSelection$-73" (was $-72 for a while, and $-71 prior to
that), and there is a small square that blocks out part of the word
Selection, and it's connected by a connector the length of the page, to the
box that I wanted to start with. The small square at teh top that blocks the
word has a yellow diamond shape in it. I cannot remove the connector, or the
square, thus I'm having difficulty continuing on with my page. Yesterday I
could close the app and open it again and I'd be fine, but by the end of the
day - even that wasn't a solution. Can ANYONE help me? Should I be under
development???