Word v.X doesn't print tables properly in Panther

[B Maxwell]

Printing tables in Word v.X in Panther causes the tables to lose portions near
the edges (top and bottom or left and right depending on orientation of the
page), as if the margins are set inside the table boundaries. Does not
happen to versions prior to update 1.2 (but there are other issues then). Did
not happen with any update in Jaguar.

 

[John McGhie [MVP - Word]]

Try removing and replacing your printer driver. It sounds as though the
driver for the printer you are using is not correctly reporting the
boundaries of the print area.

Make sure that you are formatting the document for that specific printer and
not "Any Printer".

Having gone up to a level of the operating system, certain printing
measurements may change slightly. Go up to 10.3 before you spend any
serious time on this issue, because it all may change again

Hope this helps

Printing tables in Word v.X in Panther causes the tables to lose portions near
the edges (top and bottom or left and right depending on orientation of the
page), as if the margins are set inside the table boundaries. Does not
happen to versions prior to update 1.2 (but there are other issues then). Did
not happen with any update in Jaguar.

--

Please respond only to the newsgroup to preserve the thread.

John McGhie, Consultant Technical Writer,
McGhie Information Engineering Pty Ltd
Sydney, Australia. GMT + 10 Hrs
+61 4 1209 1410, mailto:[email protected]