M
Mike S
(also posted in the visio.developer.shapesheet section)
I have drawings using the Zones-8 master from the Title
Blocks stencil. Using Visio 2003, SP 2. They scale fine for smaller drawings,
but when the drawing gets over 50-60 inches wide, the text no longer gives
one digit in each zone, but instead puts the last 2-3 digits in a zone before
the end. For example, instead of 1-2-3-4-5-6-7-8, at 50" I get
1-2-3-4-5-6-78-- and at 60" I get 1-2-3-4-5-678---. This behavior does not
occur in earlier Versions of Visio, but it occurs in 2003, wheter I am
creating a new file in Visio 2003, or opening a file created in an earlier
version. I have found the same thing with multiple computers using Visio
2003. Any ideas what is causing this behavior and how to correct it?
I have drawings using the Zones-8 master from the Title
Blocks stencil. Using Visio 2003, SP 2. They scale fine for smaller drawings,
but when the drawing gets over 50-60 inches wide, the text no longer gives
one digit in each zone, but instead puts the last 2-3 digits in a zone before
the end. For example, instead of 1-2-3-4-5-6-7-8, at 50" I get
1-2-3-4-5-6-78-- and at 60" I get 1-2-3-4-5-678---. This behavior does not
occur in earlier Versions of Visio, but it occurs in 2003, wheter I am
creating a new file in Visio 2003, or opening a file created in an earlier
version. I have found the same thing with multiple computers using Visio
2003. Any ideas what is causing this behavior and how to correct it?